Satillite Dish On Metal Roof

A dish mast installed on a traditional wood framed structure should be secured with 6 lag screws.

Satillite dish on metal roof. The style and height of roof determine where the satellite dish goes on the roof. Normally a rubber sheet will be installed with the screws to ensure that it stays and doesn t leak. Then holes are drilled into your roof to secure it in place. Many who aren t intimately familiar with these systems including roofers might see it as one big hunk of metal.

An alternative satellite dish mounting location is at the top of a sturdy metal or wood pole. It only intersects with their work area at one location the roof. To properly install a mount on the roof a rafter has to be located underneath the shingles. The dish assembly and the mounting bracket.

One of the best ways to set up a dish is by anchoring a metal pole in the ground with concrete then mounting the dish on top of it. Two in the center secured into a wall stud or roof rafter and four secured in the corners of the mount. These holes pierce all layers or protection that your bryan roofer installed including the waterproof underlayment and seals. As opposed to your roof a pole offers you much more flexibility for satellite placement and can help you avoid signal loss if you choose a completely unobstructed location.

Armed with a drill the installer will drill holes directly into your roof in order to bolt on the satellite dish mount. How can i install a satellite dish on my roof without causing a leak. Even a small 18 inch dish can excerpt a lot of force on a dish mast. Usually four to six holes are drilled through the roof to complete the install.

The pole gives the dish more height without it needing to be on the roof. The pole should be adequately anchored with concrete under the ground to stabilize the dish during windy weather. Satellite dish installationsmast installation. The mast must be secured to withstand years of wind loading.

So they often unbolt the footplates and remove the dish.